Why does my pioneer receiver keep shutting off?

Hear this out loudPauseIf amplifier turns itself off when speakers connected, check their impedance, check the wiring of the speaker that caused it to stop working. If the amplifier is still turning off with no speakers or wires connected to the amp., it will have to be opened and checked for bad components.

How to change receiver settings on pioneer vsx-914?

1 Switch the receiver on. button for about three seconds. display, press the TONE button. OK? shows in the display. 4 Press TONE once more to confirm. Hope this helps some. i tried your tip.. but the unit wont even power on to try and reset the settings.

Why does my pioneer TV have no sound?

The cable box needed to be reset in the first place, but you reset the receiver to factory defaults instead. That is why when you rebooted the cable box, the sound cam through the TV speakers instead of the receiver. So, you need to set the receiver up, just like you did when the unit was brand new.

When does the pioneer a / V receiver shut off?

It doesn’t matter what function we’re using, whether it’s using our Shaw DVR or watching a blu-ray or plugging in our iPod, it will shut off. Either 10 seconds after we turn it back on or a few minutes.

Why is my pioneer VSX D812 not powering on?

My Pioneer VSX D812 can still power on (LED not flashing) but can not detect audio and video signals due to a extremely low voltage earlier this month. The tuner is still working. I hope someone can help me revive it.

It doesn’t matter what function we’re using, whether it’s using our Shaw DVR or watching a blu-ray or plugging in our iPod, it will shut off. Either 10 seconds after we turn it back on or a few minutes.

The cable box needed to be reset in the first place, but you reset the receiver to factory defaults instead. That is why when you rebooted the cable box, the sound cam through the TV speakers instead of the receiver. So, you need to set the receiver up, just like you did when the unit was brand new.

Why is the O2 Jack not working on my pioneer?

The receiver should be defaulting back to “A” because that is “Analog” which is what those Red and white cables are from the cable box to the receiver. O2 is the “Optical 2” jack, and you’re not using that connection, so what’s happening is the receiver is searching for an audio signal from the Cable Box and not finding one.

What to do if your pioneer amplifier keeps turning itself off?

If it appears to operate normally, reconnect one speaker at a time, testing low and high volume levels before adding more speakers. If the amplifier still keeps turning itself off with no speakers, take it to a repair shop. Pioneer will have information on their website as to the locations of their authorized service centers in your area.